The Xbox One console is a fantastic package itself. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, increasing numbers of people find reasons to modify the said game console, or its accessories. The type of modification is a reaction to build a rapid fire modded Xbox One console controller. Listed below are the steps on how to modify your original controller to some rapid fire controller.
The first step. Unscrewing the controller
Before starting taking your controller apart, please take a critical look on the controller first and try to remember which parts go where since you will eventually need to put everything rear. Start by unscrewing each of the visible screws behind. After that, before you decide to tug on the case, take away the batteries to show the hidden screws. Remove these as well.
Step 2. Preparing the Case
Using the controller facing down, slowly and thoroughly separate the leading 1 / 2 of the casing through the circuit board. A hole in the case will ultimately are necessary. Don’t forget this before putting things back.
3. Placing The Rapid Fire Button
While other methods of modifying the controller tend not to involve installing a brand new button, this kind of guide does. In addition this help you to adjust the interest rate of rapid fire, it minimizes tampering with other areas of the circuit board, thereby minimizing potential risk of damaging your modded Xbox One controller.
Remember, kits to the rapid fire controller are available easily. It’s the button out of this kit that will be placed over the hole in the casing, so put it gently before the circuit board is returned. You may have to snip out a few flaps to make way for the wires with the kit. You can do this with the cutter or a couple of scissors.
Step . 4. Soldering
Assuming that you understand how to properly utilize a soldering iron, attach the red wire on the leftmost pin of the 4-pin horizontal series, even though the blue wire solders towards the rightmost pin the exact same series. The black (or green occasionally) wire attaches on the core three vertical series to the right with the switch.
Soldering is the most crucial key to making the modded Xbox One console controller. For the reason that mistakes made with this stage can permanently damage your controller.
Step # 5. Putting xbox one custom controllers paying attention to the wires, try to close the circuit board and the casing. This is usually a little tricky as the new wires is certain to get in the form of things. Find a way because of these wires to occupy the empty spaces instead of stuffed. You could possibly support the modded Xbox One system controller facedown so the buttons don’t fall and maneuvering the wires certainly are a little easier. Position the casings together try not to return the screws yet.
You need to find out if the rapid fire buttons work. If they don’t, you may need to restart your console and the now modded Xbox One controller. This should solve the challenge. When it doesn’t then you can have to go from the steps again to make sure.
More information about rapid fire controllers xbox one web portal: read here.