The Xbox is already an incredible package itself. However, with games like Cod 5, Modern Warfare, and Modern Warfare 2, more and more people find reasons to modify the said gaming console, or its accessories. One such modification is often a reaction to develop a rapid fire modded Xbox One controller. Listed here are the steps on how to modify your original controller to a rapid fire controller.
Step one. Unscrewing the controller
Before you begin taking your controller apart, require a critical look at the controller first and continue to remember which parts go where because you will eventually need to put everything rear. Begin with unscrewing each of the visible screws at the back. Next, when you tug on the case, remove the batteries to disclose the hidden screws. Remove these also.
Step two. Preparing the truth
Using the controller facing down, slowly and carefully separate leading 50 % of the casing in the circuit board. A hole in case may ultimately are necessary. Don’t forget this before putting things back.
Step 3. Placing The Rapid Fire Button
While other ways of modifying the controller don’t involve installing a whole new button, this type of guide does. Not only does this assist you to adjust the rate of rapid fire, it minimizes tampering along with other aspects of the circuit board, thereby minimizing the potential risk of damaging your modded Xbox One controller.
Remember, kits to the rapid fire controller can be bought easily. It does not take button because of this kit that is to be placed from the hole inside the casing, so install it gently before the circuit board is returned. You might need to snip out a few flaps to produce method for the wires from the kit. You can do this with sometimes a cutter or perhaps a set of two scissors.
Step four. Soldering
In the event that you probably know how to properly utilize a soldering iron, attach the red wire for the leftmost pin of the 4-pin horizontal series, as the blue wire solders for the rightmost pin of the same series. The black (or green in some instances) wire attaches for the center of the three vertical series to the correct in the switch.
Soldering is the most crucial the answer to making the modded Xbox One system controller. It is because mistakes made during this stage can permanently damage your controller.
Step five. Putting everything back
Carefully considering the wires, attempt to close the circuit board and the casing. This may be a little tricky for the reason that new wires is certain to get in the way of things. Have the option for these wires to occupy the empty spaces as opposed to herniated. ps4 mod controllers may support the modded Xbox One console controller facedown so your buttons don’t fall and maneuvering the wires can be a little easier. Place the casings together such as the return the screws yet.
Congratulations, you need to find out if the rapid fire buttons work. If they don’t, you may have to restart your console along with the now modded Xbox controller. This will solve the challenge. If it doesn’t you might need to go with the steps again to double check.
For more info about xbox one modded controllers explore our web portal.