One of the first things the do-it-yourselfer realizes while studying how to construct a drywall ceiling is no man can be an island – unless he makes use of rented equipment! Since the panels are big, bulky, and awkward, hanging drywall with a ceiling entails either: assistance from another person or renting a drywall jack from your local store. The cable mechanism on drywall jacks isn’t tough to operate, and jacks do a great job of holding the drywall in a secure, flat position helping you to more easily attach it to the ceiling.
Tools & Materials
Building a Drywall Installation Cost includes understanding what all tools and material you will need. In addition to either another person to help you or even a drywall jack, you will also have to have a hammer, a drill which has a screwdriver bit, and nails or screws for drywall. You can also, obviously, must measure your ceiling (twice!) and get enough drywall, together with a little extra in case there is mistakes, to complete the job.
Mark Joists First
Find the boards – usually 2x4s or 2x6s – that serve as ceiling joists by tapping along the wall studs which has a hammer and following inside the wall to the ceiling. As part of finding out how to build a drywall ceiling, mark where these boards are placed which has a pencil. These are generally what will you be attaching the drywall to and marking them beforehand causes it to be quicker to find them than attempting to find them while nailing or screwing for the drywall. Then you definitely must measure where the light fixture continues on the drywall and remove an opening to accommodate that part of the ceiling.
The Tough Part
It’s part in mastering how to construct a drywall ceiling where you will need each other (who hopefully has lots of stamina as well as strength!) to hold the drywall up to the ceiling or squeeze drywall panel for the jack. Set the end from the sheet of drywall – having its finished side facing down – at the center from the ceiling board (joist) to which you are going to nail it. Nail around the outside the panel in regards to a one-half inch in the edges in order to avoid the drywall from splitting or cracking. The one who is holding the panel can move or, should you be employing a jack, you’ll be able to move out of the way.
Make It Pretty
Countersink nails or screws at six- or seven-inch intervals all along the whole joist to which the drywall continues to be attached. Countersinking lets you mask the heads from the nails/screws with compound in order that when you paint, the heads will not in any way visible. While not really a section of understanding how to develop a drywall ceiling, finding out how to mask ugly nail or screw heads serves its very own purpose for overall general carpentry knowledge.
For more information about Drywall Installation Cost have a look at our site: check