One of the primary things the do-it-yourselfer realizes when studying how to construct a drywall ceiling is always that no man is an island – unless he makes use of rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall over a ceiling entails one or the other: the assistance of another individual or renting a drywall jack out of your local store. The cable mechanism on drywall jacks just isn’t hard to operate, and jacks do a fantastic job of holding the drywall in the secure, flat position helping you to more easily attach it to the ceiling.
Tools & Materials
Developing a Ceiling Drywall Repair includes being aware of what all tools and material you will need. Together with either another individual to assist you or perhaps a drywall jack, you can also have to have a hammer, a drill which has a screwdriver bit, and nails or screws for drywall. Included in the package, naturally, need to measure your ceiling (twice!) and buy enough drywall, together with a little extra in case of mistakes, for the task.
Mark Joists First
Get the boards – usually 2x4s or 2x6s – that function as ceiling joists by tapping along the wall studs which has a hammer and following up the wall to the ceiling. As part of learning how to create a drywall ceiling, mark where these boards can be found which has a pencil. These are generally what will you be attaching the drywall to and marking them beforehand makes it much easier to find them than trying to find them as you are nailing or screwing around the drywall. Then you definitely need to measure the location where the fitting proceeds the drywall and reduce a dent to accommodate that area of the ceiling.
The cruel Part
Now’s the part to learn how to construct a drywall ceiling where you will need your partner (who hopefully has a good amount of stamina along with strength!) to hold the drywall up to the ceiling in order to position the drywall panel around the jack. Squeeze end in the sheet of drywall – featuring its finished side facing down – in the center in the ceiling board (joist) that you are going to nail it. Nail around the away from the panel about a one-half inch from the edges to avoid the drywall from splitting or cracking. The one who is holding the panel is now able to move or, should you be utilizing a jack, it is possible to move out of methods.
Allow it to be Pretty
Countersink nails or screws at six- or seven-inch intervals all along the length of the joist that the drywall has been attached. Countersinking allows you to conceal the heads in the nails/screws with compound to ensure that if you paint, the heads won’t be at all visible. While not a legitimate portion of knowing how to develop a drywall ceiling, learning how to conceal ugly nail or screw heads serves its purpose for overall general carpentry knowledge.
More details about Ceiling Drywall Repair check out our new resource: learn here